30's repro alphabet
93 by 70 inches
Here is a link to the free booklet:
https://www.fatquartershop.com/moda-spell-it-with-fabric-quilt-free-pdf-pattern
I made lots of changes in construction. Their directions are for using 2 1/2 inch strips. Because I used scraps and yardage I was able to simplify many of the letters. For example, their Z uses 13 pieces. I made it with 5.
I think I started with 4 yards of the green and very little was left at the end.
I don't remember the manufacturer or the color name. It is a fabulous green!
Here are my directions for this 30's repro set. I earlier put up directions for the modern set.
All the squares used for the setting sashings, cornerstones, and 16-patch border were from my bins--none needed to be cut for this set. And many remain for future endeavors.
Make the letters. They will measure 8 1/2 by 10 1/2 inches, to finish 8 by 10.
Make four scrap blocks for the corners
Cut 80 squares 2 1/2 inches
Sew into rows of 4
Sew five rows into blocks that will be 4 by 5, 20 squares. They will measure 8 1/2 by 10 1/2 inches, to finish 8 by 10
Sashing
I used about 640 scrap squares for the sashings and about 184 more for the corner stones. These numbers may be way off, I just used them from my bin of 30's repro scrap squares.
Hint with sashing: cut the solids along the length of grain--long part of sashing parallel to the selvage--the stability of length of grain is always helpful with sashing.
Theoretically, you could make the same look for the sashing by bordering each block with the solid then making sashings with just the 1 inch finished squares. However, these would be very fragile and unstable, so I instead sandwiched them between two solid sashings.
 |
| sashing (A is pictured) |
The vertical sashes
Make 36 of this size
Cut two 1 1/2 by 10 1/2 inch solid for each sashing, so 72 total
Cut ten 1/12 inch squares of prints, so 360 total
Sew prints into a row. Press in one direction
Sew solid on each side of the squares. Press towards the solid
Sashing B
The horizontal sashes
Make 35 of this size
Cut two 1 1/2 by 8 1/2 inch solid for each sashing, so 70
Cut eight 1/12 inch squares of prints, so 280 total
Sew prints into a row. Press in one direction
Sew solid on each side of the squares. Press towards the solid
 |
| cornerstones |
Cornerstones made with 184 scrap 1 1/2 inch cut squares, 120 green squares and a few 1 1/2 by 2 1/2 inch and 1 1/2 by 3 1/2 inch rectangles.
Scraps:
1 1/2 inch squares
Solid:
1 1/2 inch squares
1 1/2 by 3 1/2 inch rectangles
1 1/2 by 2 1/2 inch rectangles
The interior cornerstones
Make 20
The edge cornerstones (except for the corners)
Make 18
Cornerstone C
The actual corners!
Make 4
They can be all made the same or, like I did, with the long green kept in the horizontal position
Assembly
Sew Sashing A onto the left side of all blocks and also to the right side of the blocks that will be on the right side of the quilt (that will be two of the scrap square blocks and the letters H, M, R, W.
Sew the rows.
Press blocks towards the sashings.
Lay out rows and remaining sashings and corners.
The corners are constructed in a way that the outside will be of the solid fabric.
Press cornerstones towards the sashings.
Sashing can be simplified with a 3 1/2 inch cut solid, or if you like the pieced one but don't want to bother with all the tiny squares, replace that center section with a print or another solid cut 1 1/2 by 8 1/2 and 1 1/2 by 10 1/2. The cornerstones can be simple squares cut 3 1/2 inches too instead of 9-patches.
At this point the top measures 81 by 58 inches finished (81 1/2 by 58 1/2 by measuring)
Borders
I made borders out of about 816 2 inch cut squares sewn into 16-patches. (and 16 rectangles 2 by 2 1/2 inches cut for the centers of the top and bottom borders, see note below.) Again, my numbers may be off.
For the side borders:
Thirteen and a half 16-patches for each side
For the top and bottom borders:
Five and a half 16-patches, a center unit, Five and a half more 16 patches for each.
To make the math correct, make a half-16 patch with patches cut 2 by 2 1/2 inches, one each for top and bottom borders. These were placed in the center of the top and bottom borders. I think they melt into the other 16-patches well.
Press all borders towards the sashings
Finish with stay stitching the edge to keep intact until quilting.
 |
| Note the larger patches in the center position |
Final quilt top comes to 93 by 70 inches.
Letters are adapted from Moda's Spell it with Fabric pattern.
Setting is my design.
Use my setting at your pleasure.
No comments:
Post a Comment